Paraview Crash when opening vtk file

ParaView Support
1

Hello, I am trying to open a vtk file but Paraview crashes after loading few seconds without any error or warning message.

However, when I open other file, the Paraview works fine.

I deleted some CELLS in the vtk file, for very small total numbers, like 1, 10, it can work. but for large numbers, 1K, 10K, it still crashes.

I have attached the vtk file in here, please check this out. Thank you for your support!
Beam.vtk (2.5 MB)

2

File is probably mis-formated, In any case, this is causing a segfault so it should be fixed.

Can you open an issue : https://gitlab.kitware.com/paraview/paraview/-/issues ?