Hi, I have a curved pipe with a sharp bend, and I want to integrate quantitates on a cross-section. In previous versions of ParaView, I used to make a slice on the cross-section, followed by clipping the plane with a short cylinder to get rid of parts of the mesh that were clipped elsewhere (as the…

Hi, I have just tested clipping the volume with a cylinder, and I had the same behaviour as clipping a slice – the clip selected the full cells inside the cylinder, but did not cut them with the cylinder shape before. If clipping the volume would have worked, I could have changed the order from sl…

Hi, I’ve just tested cylinder clip with ParaView 5.0.1, with which I had the same issue. Perhaps the good clipping I used to have before was related to also having a good volume mesh. The volume cells of this mesh have terrible aspect ratio. Nevertheless, the behaviour of the cylinder and sphere cl…

Just a change of behaviour, use the “inside out” property.

ParaView

Problem clipping a slice with a cylinder

Development

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled